Vicon RV 4116, Operation And Maintenance Manual

Page: 42 / 192

▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬ General information about the machine
4
83-004-0.
fm
ID
M
English
- 36 -
Part 2
ELECTRONIC AND ELECTRIC DEVICES
29
The list shows the description and the functionality only of some electric
and electronic devices.
For further details, see the booklets about the functional assemblies that
are installed in the machine in paragraph "Electronic and electric devi-
ces".
–
Secondary electronic control unit ECU (A): manages the process-
es of operation of all the mechanisms installed on the machine (feed-
ing unit, binding unit, etc.).
–
Electric motor (B) : it drives the net/twine introduction device.
–
3-pole plug (C) : it is used to connect the electric system of the binder
unit to the tractor.
–
Sensor (D) : it detects the position of the hooks to close the tail gate.
–
Potentiometer (E) : it detects an excessive accumulation of product
on the right side of the bale being pressed. The information is shown
on the display of the electronic control system, so that the operator
can modify the trajectory of the tractor.
–
Potentiometer (F) : it detects an excessive accumulation of product
on the left side of the bale being pressed. The information is shown
on the display of the electronic control system, so that the operator
can modify the trajectory of the tractor.
–
Potentiometer (G) : it detects the diameter achieved by the bale.
–
Sensor (S2): detects the position of the wire/net inserting device
(front end of stroke), enables the stop of the electric motor (B) and
resets the system
C
D
E
G
F
A
S2
B
ID
M
-48300400200.
pdf