Vicon RV 4116, Operation And Maintenance Manual

Page: 49 / 192

4
83-004-0.
fm
ID
M
English
- 43 -
▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬ General information about the machine
Part 2
8. Adjust the support (G) so that
the eye of the drawbar is at the
same height of the towing eye
of the tractor.
9. Unscrew the nuts (H) , and then
remove the screws (L) .
Important
One screw (L) must be left inside
in order to use it as fulcrum for
the eyelet, and thus make opera-
tions easier.
10. Place the eyelet (M) in horizon-
tal position.
11. Introduce and tighten the
screws (L) .
Important
At the end of the operation,
check that the locking screws
are correctly tightened to pre-
vent the risk of detachment be-
tween the drawbar and the eye.
HOW TO SET THE LENGTH OF THE CARDAN SHAFT
36
Follow the instructions.
1. Check the length of the cardan shaft only after having decided the
tractor to which the machine has to be coupled to.
The cardan shaft must be long enough so that it does not jam
at its minimum extension or slip out at maximum extension.
2. Couple the machine to the tractor without assembling the cardan
shaft (See "How to couple the machine to the tractor").
G
ID
M
-21722101600.
p
df
L
ID
M-21
722101700.
p
df
Hole (II) - Height 900÷1000 mm
H
Hole (I) - Height 450÷500 mm
M