Vertiv
|
XTE 802 Series Walk-In-Cabinet (WIC) Description & Installation Manual (631-205-434)
|
Rev. D
49
Tools and Test Equipment Required for Installation
The following tools, test equipment and materials are required for the physical installation of the WIC:
•
Non-contact voltage detector
•
Digital multimeter (DMM), 0 to 200 V dc, 0 to 300 V ac
-
Digital clamp-on meter, 0 to 30 A dc, 0 to 60 V ac, recommended
•
Torque wrench
•
Ratchet drive, extensions, sockets
•
Carpenter’s level
•
Lineman’s scissors
•
Lineman’s strippers
•
Lineman’s cutters
•
Appropriate crimping tool with dies
•
Electrician’s insulated screwdrivers, Phillips, No. 1 and 2
•
Electrician’s insulated screwdrivers, flat-blade, small and large
•
Insulated nut drivers for battery installation.
•
Silicone sealant
•
NO-OX-ID-A or approved equivalent
Outside the scope of this document, are the tools to fish, splice and terminate OSP Cables and laptop to setup
the power system controller.
Equipment associated with lifting the WIC by the eyebolts is listed separately, in a subsequent section.
