Vertiv
|
XTE 802 Series Walk-In-Cabinet (WIC) Description & Installation Manual (631-205-434)
|
Rev. D
46
SEQUENCE OF PROCEDURES
General
Perform the procedures in
(in the order listed) to fully install the WIC.
Other practices and manufacturer’s documents will be required to complete the installation of the system. This
includes, but is not limited to:
•
Setup and maintenance of rectifiers, controller, and batteries.
•
OSP cable fishing, sealing, grounding, splicing, and termination.
•
Equipment manufacturer’s drawings and documentation.
•
Refer also to…
-
SD-2018009-01 (WIC Schematic Drawings).
-
J-2018009-01 (WIC Job Drawings)
Table 3:
Sequence of Procedures
Section in this
Document
Starting on
Page
Description
Provides information that will help the project engineer determine an
appropriate use and location for the WIC, including associated
foundation options.
Describes the front door and operation of the front door intrusion
alarm switch.
Provides installation overview.
Describes the transportation and storage requirements, the safe
handling of the WIC, and the procedures to install the WIC and
associated foundation options.
Provides methods for sealing cable entries.
Describes the grounding requirements for the WIC.
Provides wiring information for the electrician.
Provides information regarding the DC power system and
distribution.
Provides reference where to find information and installation
instructions for the various models of batteries used in the WIC.
Provides external DC generator wiring instructions.
Provides procedures for preparing the cable sheaths and routing the
cables within the WIC.
Describes the wiring for the WIC alarms.
Describes the power up sequence for the AC power, the DC power,
and the batteries.
Describes the WIC thermal components.
