Vertiv F2019015, Description And Installation Manual

Page: 25 / 100

Vertiv™ XTE 601E Series Equipment Enclosures Description and Installation Manual
Proprietary and Confidential © 2022 Vertiv Group Corp. 17
3 Sequence of Procedures
3.1 General
The procedures listed in Table 3.1 are required to be performed in the order listed to fully install the enclosure.
Other practices and manufacturer’s documents will be required to complete the installation of the system. This includes, but is not
limited to:
•
Set-up and maintenance of:
- rectifiers, converters, and controllers (if equipped).
- batteries.
•
OSP cable fishing, sealing, grounding, splicing, and termination.
•
Refer also to…
- SD-2019015-01 (Enclosure schematic drawings).
- J-2019015-01 (Enclosure job drawings)
- SD-2019016-01 (Enclosure schematic drawings).
- J-2019016-01 (Enclosure job drawings)
Table 3.1 Sequence of Procedures
Section in this Document Starting on Page Description
Product Description 1
Provides information that will help the project engineer determine an appropriate use and location for
the enclosure.
Front Door, Locks, and
Removable Panels
18
Describes how to access the internal compartments of the enclosure (equipment, battery, and cable
entry compartments). Also provides a door hinge side reversal procedure.
Installation Considerations 24
Provides installation overview, recommended tools and test equipment, required installation materials,
and recommended enclosure anchors.
Enclosure Placement 27
Describes the transportation and storage requirements, the safe handling of the enclosure, and the
procedures to install the enclosure on a pad.
Sealing Primary Equipment
Compartment Cable Entries
42 Provides methods for sealing the primary equipment compartment cable entries.
Grounding the Enclosure 42 Describes the grounding requirements for the enclosure.
AC Power 44 Provides wiring information for the electrician.
DC Power 48 Provides information regarding the DC power system and distribution.
OSP Cables 50 Provides procedures for preparing the cable sheaths and routing the cables within the enclosure.
Alarm Wiring 51 Describes the wiring for the enclosure alarms.
Batteries 57
Provides information and installation instructions for the various models of batteries used in the
enclosure.
Initial Power Up 66 Describes the power up sequence for the AC power, the DC power, and the batteries.
Climate Control Options
(F2019015)
67
Describes the operation of the F2019015 enclosure Environmental Control Unit (ECU) and thermal
components.
Maintenance, Troubleshooting,
and Replacement Procedures
78 Provides maintenance, troubleshooting, and replacement information.