Vertiv™ XTE 601E Series Equipment Enclosures Description and Installation Manual
Proprietary and Confidential © 2022 Vertiv Group Corp.
60
13.4.1
Installing and Connecting SAFT NiCd Batteries (F2019015, F2019016)
1.
Open the front door of the enclosure.
2.
Remove the front braces from each battery box and set braces and hardware aside for later use.
3.
Before installing the battery string, check the battery cabinet power cables polarity. Using a digital multimeter (DMM), make
sure the -48VDC and +0VDC are properly installed and labeled.
4.
Ensure all battery disconnect circuit breakers are in the “off” position. See Figure 13.1 for location. Using a DMM, measure the
battery power cables: Voltage reading should be +0VDC.
Figure 13.1
Battery Disconnect Circuit Breaker Locations
5.
Properly insulate the battery power cables prior to installing the batteries.
NOTE!
Batteries should be installed one level at a time.
6.
Stage the battery blocks in front of the cabinet, as shown in Figure 13.3. Follow the block orientation and polarity as shown in
Figure 13.2.
Battery Disconnect
Circuit Breaker Locations
