Vertiv™ XTE 601E Series Equipment Enclosures Description and Installation Manual
Proprietary and Confidential © 2022 Vertiv Group Corp.
11
2.9
Enclosure Features and Options
Perspective Views:
Refer to Figure 2.9, Figure 2.10, and Figure 2.11 for enclosure perspective views with major features identified
Mounting Options:
The enclosure is designed to be pad or platform mounted. It is to be lifted into place using the lifting eyebolts
provided on the top of the enclosure.
Exterior Finish Specifications:
The enclosure is finished in multistage dry powder polyester paint (Cool White) for maximum
durability and performance against corrosion.
Front Door:
The enclosure has a front environmentally sealed door that provides access to the primary equipment compartment and
battery boxes. The front door on the F2019015 includes an active heat exchanger (with fans). The front door on the F2019016
includes a DC air conditioner.
•
The front door is equipped with mounting brackets for an electronic puck-lock. The puck-lock is purchased separately.
•
The front door securing mechanism is a swing handle with multi-point rod-latch mechanism. The swing handle is equipped
with a padlock hasp that supports a lock with an arm diameter less than 3/8".
•
The front door has an intrusion alarm switch, as well as a self-locking wind latch that secures the door open during
installation or maintenance activities. Door wind latch secures at 90° and 120°. The front door has a second intrusion switch
which activates the DC light upon door entry.
•
Front door and rear access panels have EPDM rubber environmental seals.
•
Front door is field hinge side reversible.
Rear Access Panels:
Three (3) access panels are located on the rear of the enclosure. Each access panel contains 1/4 turn locks
and lift off to be removed. Panels are interlocked and upper panels must be removed before removing lower panels. Top rear access
panel cannot be removed until levers inside the primary equipment compartment are automatically disengaged by opening the front
door.
Equipment Frame:
Constructed of 7 gauge steel (0.187”), welded and painted.
•
Different configurations of 19"/23" equipment mounting rails can be configured within the equipment frame. The mounting
rails are adjustable front-to-back.
•
Single -48V string battery boxes can also be added into the bottom of the equipment frame.
•
Equipment frame is electrically-bonded to enclosure shell through mechanical means.
•
Refer to Figure 2.4 for an illustration showing the provided 19” and 23” equipment mounting racks.
Primary Equipment Compartment:
The primary equipment compartment may house:
•
Customer equipment.
•
A DC power system and DC distribution.
•
Up to two (2) battery boxes.
•
F2019015: The Environmental Control Unit (ECU) managing cooling/heating and F2019016: Hi-Temperature Alarm T-Stat.
•
A principal ground bar.
•
A 120 VAC, 15 A convenience outlet.
•
Cable entry for customer cables.
