Veit SF26, Operating Instructions Manual

Page: 63 / 149

When pressing the button, the relevant function can be activated
manually.
Cancel procedure
Screen switches to I/O check mode.
Screen switches to operating mode.
Manual mode for residual moisture control
CAUTION!
When pressing the button, the following warning
note appears:
"Do you want to activate manual
operation? Attention!!! Security functions are
limited".
Accept safety note
Cancel procedure
Calibration for residual moisture control
On the second page of the manual mode screen (MANUAL B,
page change pressing ) residual moisture control can be cali-
brated. The bust of SF26 must not be loaded with garment and the
steam lines need to be connected to the system. After pressing the
button, the procedure starts fully automatically and is completed
after approximately 10 seconds (attention: front clamp moves
up)
. Successful calibration is indicated after completion of the
cycle. Initial calibration has already been preset by the manufac-
turer. Re-calibration is only required in the event of an error (see
"Error messages" section) or when changing the cover system.
7.3.1.6.9 I/O check
Indication of the inputs and outputs currently active. The LED
colour indicates the following:
Green = input signal is active
Yellow = output signal is active
Grey = inactive
Fig. 21: Manual mode touch screen
for residual moisture control (EN)
Fig. 22: I/O check (EN)
Operation
Controls and indicators > Control panel
18.07.2017 Shirt finisher VEIT SF26 63