Veit SF26, Operating Instructions Manual

Page: 38 / 149

1.
Remove the maintenance unit from the packaging and mount
it to the provided mounting bracket on the rear side of the
machine.
2. Mount the swivel fitting with eye bolt into the maintenance
unit.
3. Slide the compressed air hose over the hose nozzle and
tighten using the hose clamp.
4. The compressed air hose must be laid in order not to contact
hot steam lines.
CAUTION!
Moving side stretchers and pressure clamps
If compressed air is applied to the device, the side
stretchers, pressure clamps and sleeve tensioning
devices move to their home position even if the
device is switched off. This movement may lead to
injuries.
Keep off the device when compressed air is
applied.
NOTICE!
Pneumatic connection ratings
For the pneumatic connection ratings, please refer
to .
1.
Install air filters
Install air filters as close as possible to the valves on the
input side. Select a filtration grade of 5 µm or smaller.
2. Install an aftercooler, air dryer or water separator (conden-
sate drain) or similar. Compressed air containing high
amounts of condensate may lead to malfunctions of the
valves or other pneumatic equipment. To prevent damage of
this nature, an air dryer, aftercooler, water separator, or sim-
ilar should be installed.
3. Remove excessive coal dust by installing a microfilter on the
input side of the valve. Large amounts of coal dust generated
by the compressor may deposit in the valve and lead to mal-
functions.
Installation
Installation > Compressed air supply connection
18.07.2017 Shirt finisher VEIT SF26 38