Scanning Tunneling Microscopy (STM)
Basic STM Operation
152
MultiMode SPM Instruction Manual
Rev. B
Set Initial Scan Parameters
1. “
Show All Items
”: Before changing any parameters, you should display all of the available
parameters. If you cannot view a parameter in a panel, you might need to enable this
parameter.
a. Click the “minus box”
in the upper left corner of the panel, and click
Show all
items
.
Figure 9.2a
Select Show All Items
b. Ensure there is a “
X
” in the check box to the left of all parameters.
Note:
Those parameters without a
X
will not display in normal Realtime mode.
Figure 9.2b
Enable Parameters
c. Click the “minus box”
in the upper left corner of the panel, and click
Show all
items
. The panel will once again appear in normal Realtime mode.
a.Click here
b.Select this
045
With “
X
”
Parameter
will display
Without “
X
”
Parameter will
not display
044
