VDO CONTISYS OBD - V3.0, Instruction Manual

Page: 44 / 144

FastCheck
42
Pre-Test conditions:
• The vehicle must be stationary.
• The ignition must be on (position II).
• An approved battery charger must be connected to ensure consistent power
supply.
Note : To remove the parking brake from Mounting Position; switch the parking brake
switch on and off twice.
Note : When the vehicle is in the 'Mounting Position' a red flashing light will appear on
the instrument cluster. This indicates that the parking brake actuator is in the
'Mounting Position'. It does not indicate a vehicle fault.
Ensure the on screen instructions on the service tool are followed precisely and in the
correct order.
Latching Position
This procedure may be necessary if the Parking Brake emergency release has been
activated, in order to re-latch the Parking brake.
Pre-Test conditions:
• The vehicle must be stationary.
• The ignition must be on (position II).
• An approved battery charger must be connected to ensure consistent power
supply.
Ensure the on screen instructions on the service tool are followed precisely and in the
correct order.
Longitudinal Accelerometer Calibration
This procedure may be necessary if the Longitudinal Accelerometer has been
replaced.
Pre-Test conditions:
• The ignition must be on (position II).
• An approved battery charger must be connected to ensure consistent power
supply.
• Ensure the vehicle is placed on a level surface and that it remains stationary
throughout the whole procedure.
• Ensure the vehicle is stationary (0 km/h) on a level surface & no apply or release
command has been received.
• Make sure the parking brake module is correctly secured to the vehicle and that
the parking brake is applied.
Ensure the on screen instructions on the service tool are followed precisely and in the
correct order.