VDO CONTISYS OBD - V3.0, Instruction Manual

Page: 40 / 144

FastCheck
38
Assembly Check
This function is used to check the operation of the parking brake system after any
work has been completed on the system.
Pre-Test conditions:
• The vehicle must be stationary
• The vehicle must be on level ground
• The vehicle must be secured with wheel locks
This function takes 25 seconds to complete.
Note : This test is automatically run as part of the 'Exit Maintenance Mode' function. It
is not necessary to perform this function if the 'Exit Maintenance Mode' function
reported no problems
Note :This function can not be performed while the parking brake system is in
maintenance mode. It should only be performed when the system is in normal
operating mode.
Ensure the on screen instructions on the service tool are followed precisely and in the
correct order.
Actuators
The following is available under the ‘Actuators’ menu option:
Static Apply
This function is used to test the operation of the actuators which operate the calipers.
This function closes the actuators to the nominal parking brake apply position.
Pre-Test conditions:
• The vehicle must be stationary
• The vehicle must be on level ground
• The vehicle must be secured with wheel locks
It should be used if it is suspected that there is a fault with the Control Module, wiring,
or the actuators (if the parking brake will not engage/disengage when manually
operated).
Note : This function can not be performed while the parking brake system is in
maintenance mode. It should only be performed when the system is in normal
operating mode.
Configuration
There are two functions available under the ‘Configuration’ menu option:
Inclination Sensor Calibration
This function is used to reset the stored zero value of the inclination sensor. It should
be used when a new Parking Brake module has been fitted or a new Inclination sensor
has been fitted.