FastCheck
49
FastCheck SAS
Connection
Using the Vehicle Application List on the CD-ROM, identify the required interface cable
for the vehicle system to be tested. Connect the cable to the service tool and secure
the fixing screws.
Note:
If the vehicle being tested is a BMW with a 20 pin connector and an EOBD
(J1962) connector, you must only use the 20 pin connector.
Note:
The Multiplexer cable (A2C59512985) or the CAN converter (A2C59512664)
harness must be used for any diagnostics on the following vehicles:
• BMW 1 series (E81/E87)
• BMW 3 series (E90/E91/E92/E93)
• BMW 5 series (E60/E61)
• BMW 6 series (E63/E64)
• BMW 7 series (E65)
If using the EOBD (J1962) pin-switchable cable (A2C59512073), ensure the settings
on the switch box correspond to the settings listed for the vehicle and system being
tested.
WARNING: Incorrect settings on the switch box may cause irreparable damage to
the vehicle's electrical system.
Ensure the vehicle's ignition is OFF.
Connect the service tool to the required vehicle connector, refer to
‘Diagnostic
connector locations’, page 79
, for further information.
Power for the service tool is provided by the vehicle connector. Once connected, the
service tool will perform an internal self test and then the screen will display the version
of the current software before displaying the main menu.
A
B
C
D
E
F
G
H
I
J
K
L
1
2
3
4
5
6
7
8
9
10
11
12
CON0017
Summary of Contents for CONTISYS OBD - V3.0
Page 1: ...Instruction Manual ContiSys OBD 02 2010 3 0 EN...
Page 2: ......
Page 143: ......
Page 144: ......