VDO CONTISYS OBD - V3.0, Instruction Manual

Page: 78 / 144

FastCheck
76
For vehicles with an iDrive (BMW 5 Series (E60/E61), BMW 7 Series (E65/E66/
E67/E68)):
• On iDrive open the menu.
• Select ‘Vehicle Settings’.
• Select ‘FTM’.
• Start the Engine but do NOT start driving.
• Select ‘Set Tyre Pressure’.
• Select ‘Yes’.
• Start to drive the vehicle, the message ‘initialising’ should be displayed on the iDrive
screen.
• The Reset process will terminate shortly after the vehicle beings to move. The
message ‘Status: Active’ should be displayed on the iDrive screen when the Reset
process has terminated correctly.
• If the vehicle is stopped while the reset is occurring the reset will be interrupted and
will be resumed when the vehicle is driven again.
For BMW 3 Series (E90/E91/E92/E93):
• Start the engine but do NOT start driving.
• Use the menu control button on the indicator stalk to move up or down until the
‘RESET’ menu item appears.
• Press the select button on the end of the indicator stalk to confirm your choice of
the Run Flat Indicator reset option.
• Hold the button down for approximately 5 seconds until the ‘RESET?’ symbol is
shown.
• Drive off. The Reset will terminate without informing the driver of success. If the
Reset has not been carried out correctly however the RPA Warning Lamp will glow
red and the process must be repeated.
• If the vehicle is stopped while the reset is occurring the reset will be interrupted and
will be resumed when the vehicle is driven again.