FastCheck
35
Dependent upon the vehicle manufacturer and model different menu options will then
be available. Function such as read and Clear DTCs will be available along with service
functions.
BMW vehicles
Note
: To switch the ignition ON for vehicles fitted with a start/stop button, insert the
remote key-fob fully into the ignition slot then press the start/stop button once (without
any foot pedals depressed).
Note
: The Multiplexer cable (A2C59512985) or the CAN converter (A2C59512664)
harness must be used for any diagnostics on the following vehicles:
BMW 7 series (E65)
BMW 7 Series (E65)
Parking Brake Bedding-in
If the brake shoes of the ‘Duo Servo Brake’ are replaced then the bedding process
must be performed to ensure correct operation of the system. The procedure may be
performed on a roller test rig or on a road test drive.
Automatic hold
The Automatic hold function applies the brakes when the vehicle is stationary and
applies the brakes and parking brake when the engine is switched off. This function
can be disabled / enabled.
Assembly mode
Unintentional operation of the parking brake button before the Bowden cables have
engaged in the wheel carrier can lead to assembly problems. Assembly mode
suppresses the activation of the parking brake.
Positioning travel check
If excessive travel has been detected then a warning is displayed and fault stored. This
procedure is used to determine the cause of the problem detected by the system.
BMW X5 (E70) / X6 (E71)
Workshop mode
While in workshop mode the parking brake is placed into the opened position and the
system is disabled.
Parking Brake Bedding-in
If the brake shoes of the ‘Duo Servo Brake’ are replaced then the bedding process
must be performed to ensure correct operation of the system. The procedure may be
performed on a roller test rig or on a road test drive.
Summary of Contents for CONTISYS OBD - V3.0
Page 1: ...Instruction Manual ContiSys OBD 02 2010 3 0 EN...
Page 2: ......
Page 143: ......
Page 144: ......