Power Supply
Instruction manual Operating table TruSystem 7000 – 1 730 263 – 11/2016
47
8.3
Charging the operating table
The operating table should be charged daily after use in the OR to
ensure it is always ready for use.
The battery charge status can be seen on indicator [a1] on the
column keypad. Observe the indicator while using the operating
table. The operating table has to be charged if the indicator lights
red. In addition, an audible signal sounds that repeats at intervals of
a few minutes.
1. Connect an external power supply to the operating table (see
section 8.2 on page 44).
Indicator [a3] on the column keypad lights up.
Indicator [a1] on the column keypad flashes green within
1 minute after plugging in the power cable.
2. The operating table is charging.
If the batteries are completely discharged, recharging will take
approximately 3 hours. Indicator [a1] on the column keypad
lights green when the batteries are fully charged.
Once charging is complete, the charging current is reduced to
a maintenance charging current. The maintenance charging
current will not damage the batteries.
3. Disconnect operating table from the external power supply
(see section 8.2 on page 44). Indicator [a3] on the column
keypad goes out.