Control Units
36
Instruction manual Operating table TruSystem 7000 – 1 730 263 – 11/2016
6
Control Units
The operating table can be controlled by using the following
control units:
• Column keypad
• Remote control
• Foot control
The control unit [12] female connector on the operating table is
used exclusively to connect the wired remote control or the foot
control.
Entries via keys at the individual control units are accepted in the
following sequence (priority):
1. Column keypad
2. Wired remote control
3. Foot control
4. Cordless remote control
Simultaneous activation of multiple keys will result in the sounding of
alarms or in the execution of table functions in order of priority.
6.1
Column keypad
6.1.1
Overview of functions
The operating table is displayed on the column keypad in a
simplified graphical form. The top section of the graphic
representation shows the functions of the operating table, with the
functions of the operating table column below (viewed from the
head end). The keys for the adjustment functions are identified by
arrows and arranged according to table segment. The direction of
movement for the individual functions corresponds to the image
displayed.
The individual functions on the column keypad can only be selected
once the keys are unlocked. To activate an operating table function,
press and hold the function key on the keypad until the desired
position is reached. The function stops when the key is released. The
keypad is locked again automatically ten seconds after the last key
press. The
O
FF
button is an exception. The operating table can be
turned off at any time using the
O
FF
button on the column keypad.
The column keypad functions can also be selected using two-key
control. Press the
O
N
key and simultaneously press the desired
function key. The keypad does not need to be unlocked prior to
two-key control.