Trilithic EASy-PLUS, Operation Manual

Page: 74 / 114

EASyPLUS Encoder/Decoder - Operation Manual V8.09
72
Editing an IP Switch Device
To edit an IP switch device in the list of managed devices, perform the following
procedure.
1. Select the IP switch device to be edited in the IP Switch Devices list,
then click the Edit button.
2. The pop-up IP Switch Settings window will appear.
Edit the device by following the procedure outlined in Chapter 5: EASyPLUS
Configuration , The IP Devices Tab , Configuring an IP Switch Device , Adding
an IP Switch Device .
3. Click the OK button to complete the process.
Deleting an IP Switch Device
To delete an IP switch device from the list of managed devices, perform the following
procedure.
1. Select the device to be deleted from the IP Switch Devices list, then
click the Delete button.
2. A status window will briefly appear; after the window closes, the selected device
will no longer be displayed.
Testing an IP Switch Device
To perform a test of an IP switch device, first select the device to be tested from
the
IP Switch Devices
window. This test is used to verify connectivity between the
EASyPLUS Encoder/Decoder and remote IP-controlled contact closure switches.
Use the
Test Mode
pull-down list to select whether the IP
switch will be turned ON or OFF in the test.
Click the
Test
button to set the switch to the desired state.
In order to return the contact closure to its normal position, use the Test
Mode
pull-down list to select the outputs off condition, then click the
Test
button.