Transition Networks
S4224 Web User Guide
33558 Rev. C
Page 594 of 669
Message
:
syslog Clear Level = %ld
syslog message get info fail!
syslog server address to set is: %s
Testing syslog number %d
(prefix:
Debug
,
Info
,
Warning
, etc.)
Meaning: You entered an invalid Syslog entry.
Recovery:
1. Select a valid Syslog entry.
2. See “
Log (System Log) Configuration
” on page
32
.
Message
:
txt2ipv4 failed for tnIpAddr = %s (IP Mgmt Table Entry)
txt2ipv4 failed for tnSubnetMask = %s(IP Mgmt Table Entry)
Configuration failed (DefaultGateway table entry)
Meaning
: An error occurred when configuring the DNS Server table.
Recovery
:
1. Select a valid DNS entry at
Configuration
>
System
>
IP
.
2.
See “
IP Configuration
” on page
Message
: >
E api/cil 00:05:10 28/l26_action_check#5539: Error: ACL policer and EVC policer
cannot both be enabled
Meaning
: Two means of policers cannot be enabled together.
Recovery
:
1. Disable one or the other.
Message
:
Error: Part of the VLAN configuration didn't apply as some of ports are in forbidden list for a given VLAN id.
Error: Part of the VLAN configuration didn't apply as some of ports are in member list for a given VLAN id.
notice: forbidden port cannot overlap with egress member port in MIB setting.
Meaning
: The system does not allow changing VLAN member ports once there is forbidden port (or
ports) in this VLAN.
Recovery
:
1. Change either the VLAN member ports configuration or change the VLAN forbidden ports
configuration.
2. See the “
Configuration
>
VLANs
>
VLAN
Membership
” section of this manual.
Message
:
Warning: FPGA 1.1 required
Warning: FPGA 2.x required
Meaning
: The S4224 does not automatically reboot after FPGA upgrade, but should be rebooted to ensure
proper operation.
Recovery
: We recommend upgrading the FPGA first, then the software, because the unit will
automatically reboot after the software upgrade. If upgraded in the reverse order (software then FPGA),
you must manually reboot after the FPGA upgrade.
