Transition Networks
S4224 Web User Guide
33558 Rev. C
Page 532 of 669
After you set the test parameters and click the
Save
button, the test status displays:
The test status displays in the format:
Active Time Remaining
: 198
Frames
: 3,
Bytes
: 402
EtherSAT Messages
Message
:
ethersat loopback state set failed. Check that the shared port is internal and try again
etherset loopback testsideport set failed. Check that the shared port is internal and try again
etherset loopback timeout set failed. Check that the shared port is internal and try again
etherset loopback smac set failed. Check that the shared port is internal and try again
etherset loopback vid set failed. Check that the shared port is internal and try again
Meaning
: The EtherSAT loopback test failed because the shared port is not set to internal mode.
Recovery
: Set the shared port to internal mode using the (config)# command sharedport internal and try
the loopback test again.
Problem
: The S4224 or S4140 cannot be used as an Ethersat loopback device.
Workaround
: Use an S3280 or other NID as the loopback device.
Problem
: The 10GE SFP+ ports cannot be set as Test Side Ports. They can be entered and the state set
to active but refreshing the page changes them to port 1.
Workaround
: Use the 100/1000 SFP ports as Test Side Ports.
