Transition Networks
S4224 Web User Guide
33558 Rev. C
Page 156 of 669
General Settings - Global Configuration
Enable Loop Protection
Controls whether loop protections is enabled (as a whole) or disabled.
Transmission Time
The interval between each loop protection PDU sent on each port. Valid values are
1
-
10
seconds.
Shutdown Time
The period (in seconds) for which a port will be kept disabled if a loop is detected (and the port action
shuts down the port). Valid values are
0
to
604800
seconds (7 days). A value of zero (
0
)
will keep a
port disabled (until the next device restart).
Port Configuration
Port
The switch port number of the port. Note that loop protection is not supported on the MGMT/data
port.
Enable
Controls whether loop protection is enabled on this S4224 port.
Action
Configures the action to be performed when a loop is detected on a port. The valid Actions are:
Sets the action to be performed when a loop is detected on a port. Valid loop protect Action values
are:
Shutdown Port
: Shutdown the port.
Shutdown and Log
: Shutdown the port and Log the event.
Log Only
: Only Log the event.
Trap Only
: Only send a trap.
Shutdown and Trap
: Shutdown the port and Send trap.
Log and Trap
: Send Trap and Log the event.
All
: Shutdown the port, send trap, and Log the event.
Tx Mode
Controls whether the port is actively generating loop protection PDUs, or whether it is just passively
looking for looped PDUs.
Enable
: this port is actively generating loop protection PDUs.
Disable
: this port is passively looking for looped PDUs.
Buttons
Save
: Click to save changes.
Reset
: Click to undo any changes made locally and revert to previously saved values.
