Transition Networks
S4224 Web User Guide
33558 Rev. C
Page 479 of 669
IPv6 in Windows Server 2008 and Windows Vista uses MLDv2 by default, but will use MLD if it
receives an MLD message. You can configure IPv6 to use MLD with the “
netsh interface ipv6 set
global mldversion=version2
” command.
Querier Status
Shows the Querier status as "
ACTIVE
" or "
IDLE
". The status "
DISABLE
" means the specific interface
is administratively disabled.
Queries Transmitted
The number of Transmitted Queries.
Queries Received
The number of Received Queries.
V1 Reports Received
The number of Received V1 Reports.
V2 Reports Received
The number of Received V2 Reports.
V1 Leaves Received
The number of Received V1 Leaves.
The MLD Snooping Status table
Router Port
parameters are explained below.
Router Port
Display which ports act as router ports. A router port is a port on the Ethernet switch that leads
towards the Layer 3 multicast device or IGMP querier.
Static
denotes the specific port is configured to be a router port.
Dynamic
denotes the specific port is learnt to be a router port.
Both
denote the specific port is configured or learnt to be a router port.
Port
S4224 port number.
Status
Indicate whether or not a specific port is a router port.
Buttons
Refresh
: Click to refresh the page immediately.
Clear
: Clears all Statistics counters.
Auto-refresh
: Check this box to automatically refresh the page every three seconds.
