Toshiba Strata AirLink DK40, Programming Manual

Page: 277 / 378

Least Cost Routing
Strata DK40 Programming Manual Spring 1999
5-3
LCR Exchange Line Programming Reference Table
1. Use Program 16 to assign Exchange lines in groups per the reference table below.
2. Use Program 40 to allow Exchange line access to stations using LCR for outgoing calls.
3. Use Program 41 to deny outgoing Exchange line access, except for LCR access.
4. Use Program 45-1 to enable the dial plan that is appropriate for the area where the LCR
calls will originate.
5. Under the column labelled “Exchange Line Type/ Comments,” enter the service type,
the common carrier name, or the line type for each line group, e.g., local line, ISDN30,
ISDN2 (TE), etc.
6. Refer to the Program 40 to restrict stations from incoming and outgoing access of lines,
including using LCR. All stations that must use LCR to make outgoing calls must not be
restricted in this program. These restrictions do apply to LCR.
7. Refer to Program 41 , to restrict stations from accessing outgoing lines, except through
LCR. All stations that must use LCR for outgoing calls must be restricted from line
access in this program.
Processor Exchange Line Group
DK40 1~8
Line Group Exchange Line in Group Exchange Line Type/Comments
01
02
03
04
05
06
07
08