Toshiba Q9 Series, Installation And Operation Manual, Page: 80 / 233

70 Q9 ASD Installation and Operation Manual
Direction Priority
Program

Input Terminals
The Direction Priority setting determines the disposition of the ASD if the F and
R control terminals are activated simultaneously.
Settings:
0 — Reverse
1 — Suspend
The waveforms shown depict the motor response for all combinations of the F
and R terminal settings if the Reverse option is chosen.
The Suspend setting will decelerate the motor to a stop regardless of the rotation
direction when both the F and R control terminals are activated.
Direct Access Number — F105
Parameter Type — Selection List
Factory Default — Suspend
Changeable During Run — No
Simultaneous F and R activation.
Input Terminal Priority
Program

Input Terminals
This parameter is used to allow the Jog and DC Injection Braking input signals
to control the ASD when received via the Terminal Board even though the
system is in the Local mode.
With this parameter enabled, a Jog command or a DC Injection Braking
command received from the Terminal Board will receive priority over
commands from the EOI.
See F260 for more information on using the Jog function.
See F250 – F252 for more information on DC Injection Braking.
Settings:
0 — Disabled
1 — Enabled
Direct Access Number — F106
Parameter Type — Selection List
Factory Default — Disabled
Changeable During Run — No
Option V/I Terminal Voltage/Current Selection
No Path — Direct Access Only
This parameter is used to set the AI2 input terminal to receive either current or
voltage as a control signal.
Note: The Expansion IO Card Option 2 Option Board (P/N ETB004Z) is
required to use this terminal.
See the Expansion IO Card Option 2 Instruction Manual (P/N 58686) for more
information on the function of this terminal.
Settings:
0 — Voltage Input
1 — Current Input
Direct Access Number — F109
Parameter Type — Selection List
Factory Default — Voltage Input
Changeable During Run — No
F105 F109