e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 176
4.9.7
Separation plate
Notes:
When the separation plate has been replaced or taken off, adjust the gap between the plate and
the fuser belt.
P. 6-106"6.11.4 Gap adjustment for separation plate"
(3) Remove the spring [1] and take off the
separation fingers [2].
Notes:
When installing, be sure to put the spring [1]
in the correct position as shown in the figure.
Fig. 4-505
(1) Take off the transport guide-1.
P. 4-174"4.9.3 Transport guide-1"
(2) Take off the transport guide-2.
P. 4-174"4.9.4 Transport guide-2"
(3) Take off the entrance guide cover.
P. 4-175"4.9.5 Entrance guide cover"
(4) Loosen 2 pressure screws [1] and take off 2
springs [2].
Notes:
When installing, fully tighten the 2 pressure
screws [1] until they are no longer turned.
Fig. 4-506
(5) Remove 3 screws, a rear plate [1] and a
bushing [2].
Notes:
When installing, put the harnesses in the
harness guide securely so that they are not
caught by the rear plate [1].
Fig. 4-507
[ 1 ]
[ 1 ]
[ 1 ]
[ 2 ]
[ 2 ]
[ 2 ]
[ 1 ]
[ 2 ]
[ 2 ]
[ 1 ]
[ 2 ]