6
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
SETTING ADJUSTMENT
6 - 25
[C] Image location of primary scanning direction
1. While pressing [0] and [5] simultaneously, turn the power ON.
(Adjustment Mode)
2. Place Test Chart No. TCC-1 on the original glass (with the arrow positioned at the left rear
side).
3. Press [FAX]
[START] to make a copy at the mode of A4/LT, 100%, Full color and Text/
Photo.
4. Measure the distance B from the left paper edge to the 5 mm line of left grid pattern on the
copy with a ruler.
5. Check if the distance B is within 5±0.5 mm.
6. If not, use the following procedure to change values and repeat step 3. to 5. above.
<Procedure>
(Adjustment Mode)
(Key in code [3030])
[START]
(Key in a value (acceptable values: 0 to 255))
[OK] or [INTERRUPT] (Stored in memory)
* The larger the adjustment value is, the longer the distance B becomes (approx. 0.04 mm/
step).
[D] Reproduction ratio of secondary scanning direction
1. While pressing [0] and [5] simultaneously, turn the power ON.
(Adjustment Mode)
2. Place Test Chart No. TCC-1 on the original glass (with the arrow positioned at the left rear
side).
3. Press [FAX]
[START] to make a copy at the mode of A4/LT, 100%, Full color and Text/
Photo.
4. Measure the distance C between M3 and M4 on the copy with a ruler.
5. Check if the distance C is within 150±0.5 mm.
6. If not, use the following procedure to change values and repeat step 3. to 5. above.
<Procedure>
(Adjustment Mode)
(Key in the code [3032])
[START]
(Key in a value (acceptable values: 0 to 255))
[OK] or [INTERRUPT] (Stored in memory)
* The larger the adjustment value is, the longer the distance C becomes (approx. 0.05 mm/
step).
[E] Image location of secondary scanning direction
1. While pressing [0] and [5] simultaneously, turn the power ON.
(Adjustment Mode)
2. Place Test Chart No. TCC-1 on the original glass (with the arrow positioned at the left rear
side).
3. Press [FAX]
[START] to make a copy at the mode of A4/LT, 100%, Full color and Text/
Photo.
4. Measure the distance D from the top paper edge to the 10 mm line of top grid pattern on the
copy with a ruler.
5. Check if the distance D is within 10±0.5 mm.
6. If not, use the following procedure to change values and repeat step 3. to 5. above.
<Procedure>
(Adjustment Mode)
(Key in the code [3031])
[START]
(Key in a value (acceptable values: 68 to 188))
[OK] or [INTERRUPT] (Stored in memory)
* The larger the adjustment value is, the longer the distance D becomes (approx. 0.09 mm/
step).
