11
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
FIRMWARE UPDATING
11 - 45
(7) Turn the power OFF using the main power switch on the right-hand surface of the equipment and
remove the download jig.
Notes:
When the number of blinks is other than “6” (which indicates that the adjustment value is “0”) at
the section “[A]Checking the hole punch position”, follow the steps of “5.1 Stopping Position
Adjustment” in the MJ-6102 Service Manual to adjust the value to the one that has been set
before the update.
(8) Install the finisher board access cover.
[C] Confirmation of the updated data
After the updating is completed, check each data version in Setting Mode (08) to confirm that the data
were overwritten properly.
