Toshiba B-SX4 Series, Key Operations Manual

Page: 89 / 135

- 86 -
Supplementary explanation
• When the [RESTART] and [FEED] keys are pressed at the same time, the display shows
the system mode menu.
• If the [RESTART] or [FEED] key is held down for 0.5 seconds or more when a fine
adjustment value is being set, the printer enters the repeat mode, in which the key is
entered repeatedly.
• A changed fine adjustment value is stored in memory by pressing the [PAUSE] key.
• The printer is controlled by the sum of the fine adjustment parameter programmed on the
printer and the fine adjustment command from the PC. However, the maximum values
for each fine adjustment are as follows:
Feed fine adjustment ....................................................................... ±50.0 mm
Strip position fine adjustment .......................................................... ±50.0 mm
Back feed fine adjustment ................................................................. ±9.9 mm
Print density fine adjustment ............................................................. ±10 step
X-coordinate fine adjustment........................................................... ±99.5 mm
Ribbon motor drive voltage fine adjustment (Rewind) .............. -15 to +0 step
Ribbon motor drive voltage fine adjustment (Back tension)...... -15 to +0 step
• The X-coordinate fine adjustment is performed to finely adjust the X-coordinate of the
drawing in the left or right direction. Adjust the X-coordinate in the effective print range.
(After the value reaches the coordinate “0”, the value remains unchanged even if a
subsequent fine adjustment is performed in the negative direction.)
• The X-coordinate fine adjustment is not effective for the self-test results printout
(maintenance counter, various parameters, and automatic self-test) and the test print.
• The print density fine adjustment value is +0 step at the time of shipment from the
factory.
• The ribbon rewind/back tension motors drive voltage fine adjustment values are the sum
of the fine adjustment by the command (from the PC) and the fine adjustment in the
system mode (by key operation). The maximum fine adjustment values are -15 for both
the ribbon rewind motor and the ribbon back tension motor.
• The print density fine adjustment value is the sum of the fine adjustment by command
(from the PC) and the fine adjustment in the system mode (by key operation). The
respective max. fine adjustment values are ±10. The max. value for each print speed is
as below. When the value exceeds the maximum, it is automatically corrected to the
max. value.
B-SX4 B-SX5
V1 type: TPH104R2 V2 type: TPH104R7,
or equivalent
V1 type: TPH128R4 V2 type: TPH128R5,
or equivalent
Print
speed
Thermal
direct
Thermal
transfer
Thermal
direct
Thermal
transfer
Thermal
direct
Thermal
transfer
Thermal
direct
Thermal
transfer
3 ips +10 step +10 step +10 step +10 step +10 step +10 step +10 step +10 step
5 ips ---- ---- ---- ---- +7 step +10 step +7 step +10 step
6 ips +8 step +8 step +8 step +8 step ---- ---- ---- ----
8 ips ---- ---- ---- ---- +3 step +10 step +3 step +10 step
10 ips +4 step +8 step +5 step +7 step ---- ---- ---- ----