Toro TimeCutter MX 4275T, Manual

Page: 19 / 240

Machines with 127 cm (50-inch)
Mower Decks
1. Park the machine on a level surface, disengage
the blade-control switch, and move the
motion-control levers outward to the P
ARK
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the mower deck; refer to Removing the
Mower Deck (page 49) .
4. Remove the 3 locknuts (5/16 inch) from the
welded posts of the right baffle (
Figure 13 ).
g297022
Figure 13
1. Locknut—5/16 inch (4) 3. Carriage bolt—5/16 x 3/4
inch
2. Right baffle 4. Welded post (3)
5. Remove the 2 carriage bolts and 2 locknuts
securing the right baffle to the deck and remove
the baffle (
Figure 13 ).
6. Locate the 3 bolts in loose parts and use the
existing locknuts and install these fasteners into
the holes used for the welded posts (
Figure 13 )
to prevent flying debris.
Note:
Install the bolt upward, through the
underside of the deck and use an existing
locknut to secure from the topside.
7. Remove the 2 locknuts (5/16 inch) from the
welded posts of the left baffle (
Figure 14 ).
g297021
Figure 14
1. Locknut—5/16 inch (3) 3. Welded post (2)
2. Left baffle 4. Carriage bolt—5/16 x 3/4
inch
8. Remove the carriage bolt and locknut securing
the left baffle to the deck and remove the baffle
(
Figure 14 ).
9. Locate the 2 bolts in loose parts and use the
existing locknuts and install these fasteners into
the holes shown in
Figure 14 on the mower deck
to prevent flying debris.
Note:
Install the bolt upward, through the
underside of the deck and use an existing
locknut to secure from the topside.
10. Remove the nut from the grass deflector rod
under the mower deck (
Figure 15 ).
17