Topcon mmGPS 3D Paver, Reference Manual

Page: 104 / 288

Setting up the Machine and 3DMC
mmGPS 3D Paver Reference Manual
3-34
7. Move the machine to the elevation reference point. The
measurement of this point brings the entire plane up or down to
intersect the plane and determine its relative elevation.
8. When the antenna rests over the point, press
Measure pt
to
measure the elevation reference point (Figure 3-30). The
Measuring
dialog box briefly displays.
9. Enter a grid interval and crossfall for the main screen. Press
Next
(Figure 3-30).
Figure 3-30. Measure Elevation Reference Point and Enter Grid Interval
10. Review the created surface plane (Figure 3-31 on page 3-35). If
needed, press
Back
to change parameters or measurements for
the surface. Press
Next
.
11. Press
Finish
to save the new surface file and end the process.
TIP
Substitute point A or point B for the elevation
reference point.
TIP
If you have the NEZ coordinates for the elevation
reference point, press the corresponding entry box
and type in the information.
8a
8b
9