Section 22: Connection Setup
T
ieline
Page 218
T E C H N O L O G Y
22.13.3.3.
GSM
If you are only using one GSM connection, either via a GSM module or a
cell-phone connected to the
RS232
port, it will always connect using
Port
1.
If you are using two GSM connections together,
Port 1
will be allocated
to the GSM module and
Port 2
will be allocated to the cell-phone
connection.
22.13.3.4.
IP
When configuring IP connections only one
Port
is used for each
connection. The
IP1
connection on your codec will use
Port 1
and the
IP2
connection on your codec will use
Port 2.
Remember to select a different
Codec channel
for each connection if you
are configuring two IP connections.
22.13.3.5.
X.21
When configuring X.21 connections only one
Port
is used for each X.21
module connection. For an
i
-
Mix
G
3
, the
X21 1>
connection on your
codec will use
Port 1.
22.13.4.
Commander Port Configurations
22.13.4.1.
POTS
If you are using two POTS connections with a
COMMANDER
G
3
,
Port 1
refers to the left-hand module POTS modem and
Port 2
refers to the right
hand module modem. If only one module is inserted it will use
Port 1.
22.13.4.2.
ISDN
As you can insert two ISDN modules into a
COMMANDER
G
3
, you could
have four
Ports
available which correspond to the four available B
channels. As you can only connect with a maximum of two B channels,
you will need to select the
Ports
corresponding to the B channels you
wish to connect with.
If two ISDN modules are installed,
Ports 1
and
2
correspond to the two
left hand module B channels and
Ports 3
and
4
correspond with the two
right hand module B channels.
22.13.4.3.
GSM
If you are only using one GSM connection, either via a GSM module or a
cell-phone connected to the
RS232
port, it will always connect using
Port
1.
If you are using two GSM connections together,
Port 1
will be allocated
to the GSM module and
Port 2
will be allocated to the cell-phone
connection.
22.13.4.4.
IP
When configuring IP connections only one
Port
is used for each
connection. The
IP1
connection on your codec will use
Port 1
and the
IP2
connection on your codec will use
Port 2.
