THOMSON ViBE VS7000, User Manual

Page: 27 / 276

Chapter 2 ’Installation and Startup’ — Mounting in Rack (Recommendations)
ViBE VS7000 27
User Manual
Mounting in Rack (Recommendations)
Rack mounting is not mandatory for ViBE VS7000 but the ventilation and
safety requirements given in this section must be observed in all cases.
Ventilation
Please refer to the recommendations provided by HP.
Cabling
It is essential to separate the power supply cables from the signal cables.
When facing the rear of the rack (as the device is connected via the rear
panel), the power supply cables must be guided to the right of the chassis
and the signal cables to the left.
Power Supply and Protective Ground
Power Supply Cord(s)
Specifications
The AC mains power cords are only shipped with the device if ordered.
For DC supply units, use power cords suitable with the HP specifications.
Connecting AC Mains Power Supply Cord(s)
Power Supply End
The connection panel should comply with the legislation in force in the
country of installation. The connection panel must be positioned in the
rack in such a way that the plug and power cord(s) are within easy reach
for switching off purposes.
For (each) mains inlet, the wiring system must feature overload and earth
fault protection and a bipolar cut-off device or a differential circuit
breaker. If in doubt, contact a qualified electrician.
ViBE VS7000 End
Plug the power cord(s) into the mains inlet.
„
Never supply a power supply unit which is not in the chassis.
„
The built-in overload protection cannot be accessed or reset.