THOMSON ViBE VS7000, User Manual

Page: 134 / 276

Chapter 3 ’Web Browser Interface’ — Workflow Library Content Parameters
134 ViBE VS7000
User Manual
RTMP Output
The RTMP output sends audio/video to a Flash Media Server (FMS) using
RTMP push (to TCP port 1935 of the FMS).
Adaptive bitrate is supported (a single chunker shall be defined for all the
video components).
Figure 3-108. RTMP output parameters
For this item, you must set the following parameters:
„ Flash media server URL : indicate the LAN used to communicate with
the Flash Media Server (FMS). If the FMS URL contains a name instead
of an IP address, you must configure the DNS in the
System tab, in the
IP category (see Section ’DNS’ on page 71).
If you do not wish to use the IP address resolution by DNS, you can
also directly enter the IP address of the FMS in the
Flash media server
IP address field.
„ Authentication type : choose:
™ None or in FMS URL : if there is no authentication or it is
indicated in the URL of the flash media server.
™ Akamai : if the authentication is managed by an Akamai server.
In this case, indicate the User name and Password to use.
In the Input tab, you can also set the following parameter:
„ Stream name : this parameter must be identical to all the components
of a stream. When present, an audio component should be present on
all the streams of an output.
HLS Output
The HLS output receives audio/video components, creates the chunks
and the manifests, encrypts the chunks, makes them available on the
local Web server.