THOMSON ViBE VS7000, User Manual

Page: 131 / 276

Chapter 3 ’Web Browser Interface’ — Workflow Library Content Parameters
ViBE VS7000 131
User Manual
Workflow Library: Outputs
TS over IP Streamer Output
The TS over IP Streamer output item streams an MPEG-2 TS over
UDP/IP or over RTP/UDP/IP in CBR mode (i.e. with stuffing packets). Both
multicast and unicast are supported.
Figure 3-105. TS over IP streamer output parameters
For this item, you must set the following parameters:
„ IP address : to set the IP address, click in the field. In the displayed
dialog, define if the address is multicast and if so, set the LAN. Enter
the IP address in the field. If it is a unicast address, it must be
reachable, otherwise the job creation will be refused. To check that the
address is reachable, ViBE VS7000 uses its IP configuration (LAN,
default gateways, IP routes).
„
UDP port
„ Source IP address : can be used to force the source IP address, if
needed.
„ TTL : Time-to-live field of the IP headers. This is the maximum number
of IP routers that a stream is allowed to cross.
„ MTU : Maximum Transmission Unit. This is the maximum size of a
datagram that can be streamed on the network without being
fragmented. Default value is Ethernet one (1500). This MTU also
defines the number of MPEG-2 TS packets by IP datagram. By default
this number is set to 7, but if you modify the MTU parameter, the
number of MPEG-2 TS packets by IP datagram will be the highest
allowed by the MTU.
„ Protocol : the protocol can be:
™ TS/UDP/IP : the MPEG-2 TS packets are directly in the UDP
payload.
™ TS/RTP/UDP/IP : the MPEG-2 TS packets are in the RTP payload.