THOMSON SpeedTouch 608, Cli Reference Manual

Page: 464 / 490

462
UPnP Commands
E-DOC-CTC-20040216-0002 v1.0
upnp config
Configure UPnP™ parameter(s).
SYNTAX:
where:
upnp config [maxage = <number{60-999999}>]
[defcservice = <string>]
[writemode = <{full|natonly|readonly}>]
[safenat = <{disabled|enabled}>]
[preferredaddress = <ip-address>]
maxage This parameter allows to configure how often the SpeedTouch™
sends a notification message to advertise its presence as an Internet
Gateway Device IGD) on the network.
Setting this parameter to a low value will increase the number of
packets sent over time on the network, but will make the state of
the device more up to date.
The default is
1800
.
OPTIONAL
defcservice This parameter allows to configure the connection service to be
used by the DrSpeedTouch™ application during the troubleshooting
process (only when several connection services are configured on
the SpeedTouch™, else only the default connection service). OPTIONAL
writemode Choose the set of rules to limit remote access from UPnP.
Choose between:
•
full: the host will accept all the UPnP SET and GET actions.
•
natonly: GET and NAT related SET actions will be accepted, all
other actions will be ignored.
•
readonly: the UPnP control point will only be able to retrieve
information, all the SET actions are ignored.
OPTIONAL
safenat Enable / disable check on safe NAT entries.
If this check is enabled, all NAT create/delete requests for a LAN
side IP address different from the source IP address of the UPnP
message will be discarded. OPTIONAL
preferredaddress Preferred ip address for UPnP advertisements (enter 0.0.0.0 for
none). OPTIONAL