THOMSON SpeedTouch 608, Cli Reference Manual

Page: 386 / 490

384
PPPoE Commands
E-DOC-CTC-20040216-0002 v1.0
pppoe rtadd
Automatically add a route configuration to the routing table in case the specified PPPoE interface link comes up.
This route configuration will determine which local hosts are allowed to use this link and/or which remote destinations
should be or should not be reachable.
Note
Use the command
pppoe ifdetach
for this interface prior to configuring routes.
SYNTAX:
where:
pppoe rtadd intf = <intfname>
dst = <ip-address>
[dstmsk = <ip-mask(dotted or cidr)>]
[label = <string>]
[src = <ip-address>]
[srcmsk = <ip-mask(dotted or cidr)>]
[metric = <number{0-100}>]
intf The name of the PPPoE interface. REQUIRED
dst The destination IP address for the route to be added when the link comes
up. REQUIRED
dstmsk The destination IP mask.
Depending on the destination netmask:
•
Any remote destination is reachable, i.e. the PPPoE connection acts
as default route (
dstmsk=0
)
•
Only the remote (sub)net is reachable (
dstmsk=1
)
•
The actual destination mask will be the default netmask applicable
for destination IP address
•
Only the single remote host is reachable (
dstmsk=32
)
•
Any valid (contiguous) netmask in case of Variable Length Subnet
Masking (VLSM).
OPTIONAL
label The name of the label. OPTIONAL
src The source IP address specification for the route to be added when the
link comes up. OPTIONAL