THOMSON SpeedTouch 608, Cli Reference Manual

Page: 50 / 490

48
AutoPVC Commands
E-DOC-CTC-20040216-0002 v1.0
autopvc config
Configure autopvc.
SYNTAX:
where:
autopvc config [mode = <{pseudo|passive|active}>]
[type = <{bridge|pppoerelay}>]
[opmode = <{partial|full}>]
[overwrite = <{disabled|enabled}>]
[peakrate = <number{0-27786}>]
mode Select the autopvc mode:
•
pseudo:
enable only pseudo-ILMI (VP/VC 15/16). When connection
parameters are written to the MIB, display this information on
CLI or web-interface but do not use these parameters for
configuration.
•
passive:
enable both ILMI (VP/VC 0/16) and pseudo-ILMI (VP/VC 15/
16). When connection parameters are written to the MIB,
display this information on CLI or web-interface but do not use
these parameters for configuration.
•
active:
enable both ILMI (VP/VC 0/16) and pseudo-ILMI (VP/VC 15/
16). When connection parameters are written to the MIB, use
these parameters to configure phonebook entries, qosbook
profiles and bind bridge or PPPoE interfaces on top.
The default is
passive
.
OPTIONAL
type Type of autopvc:
•
bridge
•
pppoerelay:
an ETHoA interface will be created, will be bound to the ILMI
PVC and will be added to the PPPoE relay as relay port.
The default is
bridge
.
OPTIONAL
opmode Operational autopvc mode:
•
partial: only read the ILMI VPC and VCC MIB tables
•
full: read all supported MIB tables.
The default is
partial
.
OPTIONAL
overwrite Enable/disable UBR peak rate overwrite. OPTIONAL
peakrate A number between 0 and 27786.
Represents the UBR peak rate (in kilobits per second).
Note
0 indicates the linerate.
OPTIONAL