WiPro „all in one“ Installation manual
Page 8
1.9.5 Installing the cable loop (accessory)
Choose a suitable place for installation at the back of the vehicle or
on one of the sides. You can also obtain further holders as accessories
(Item no: THA-2-00026) to use the cable loop for other areas of the vehicle.
Now carry out a range test with the wireless cable loop, as described under
1.9.3. Removing the cable loop from the holder triggers a transmission process.
Using the screws provided, fasten the holder of the cable loop to where you want to
place it using the screws provided. If you drill through the outer skin of the vehicle,
seal the drilled holes with Sikaflex to prevent the penetration of moisture.
1.9.6 Installing and connecting the back-up siren (accessory)
Choose a suitable place for mounting in the vehicle interior or in the engine
compartment. When laying the cable, make sure that it does not lie within the
range of movement of any moving parts of the vehicle, that it leaves sufficient
distance from hot engine components and cannot be exposed to wear damage
due to sharp edges. The siren must not be detached through vibration, braking
suddenly or other conditions and thereby impede the roadworthiness of the vehicle.
As with the cables, the siren must be sufficiently far away from hot engine components.
The back-up siren has an integrated rechargeable battery which is constantly
charged via the red (+12V) and black (earth) conductors. These conductors
must be connected to the on-board power supply. The back-up siren sounds if
there is a power failure (only when it is activated via the key switch.)
The white wire of the back-up siren must be connected to the white wire of the
central unit (siren +12 V). The blue wire (negative trigger) of the back-up siren
is not used (please insulate it). The back-up siren sounds when there is a
positive voltage on the white wire (only when it is activated via the key switch.)
1.9.7 Installing the central unit
Choose a suitable place in the vehicle interior to mount the central unit. The central
unit should be accessible for assigning other transmitters / wireless contacts
later but must be protected against quick access during operation later.
When laying the cables, make sure that they are not within the range of movement
of moving parts of the vehicle or pedals etc.
Ideally, choose a place for installing it near to the central electronic unit of
the vehicle in order to keep the cable lengths as short as possible.
GB
Summary of Contents for WiPro
