Network inclusion of the sensor
Put the Gateway into inclusion mode.
Remove the protective battery cover, press the networking button
for 2 seconds until the green LED starts to flash fast.
USER MANUAL ZHS20
Congratulations and thank you for purchasing the Schwaiger ZHS20 product.
Below you will find useful operating guidelines.
SMOKE SENSOR
ZHS20
BDA_ZHS20_a
Please pay attention to the fact that during network inclusion, the
distance between sensor and Gateway may not exceed 0.5 m.
3. Networking button
Press the networking button (with-
in the hole) for 2 seconds until the
green LED starts to flash fast, then
let go. The device will be detected
and included into the network.
4. Installation
of the Smoke Sensor
Select a place for installation.
5. Screw the bracket to
the ceiling OR remove the
protective cover from the
adhesive pad and stick
the bracket to the ceiling.
6. Attach the sensor to
the bracket by turning
it clockwise.
This is a smart smoke sensor which is based on the ZigBee Wireless Network-
ing technology. It has a very low power consumption which makes for longer
battery life. As soon as the sensor detects smoke, the alarm signal will sound
and the red LED will start to flash.
Network inclusion
1. Remove the protective battery cover.
To do so, remove the sensor from the
bracket by turning it counter-clockwise.
2. Put the Gateway into inclusion mode
7. Network removal of the device
Put the Gateway into removal mode by choosing „Home setup“ in the main
menu and then click on „Add device“ (See images on the left). Then reset the
device to default settings.
8. Reset to default settings (Reset)
Press the networking button for 5 seconds until the green LED starts to flash
slowly.
Note: For network inclusion, the sensor must always be in the factory state.
MANUFACTURER INFORMATION
Dear Customer,
should you require technical advice and
your retailer could not help please contact
our technical support.
Schwaiger GmbH
Würzburger Straße 17
90579 Langenzenn
Hotline: +49 (0) 9101 702-199
www.schwaiger.de
