Thitronik WiPro, Installation Manual

Page: 129 / 292

After completion of the alarm cycle and an alarm pause of about 30 seconds, WiPro is
armed again and responds to attempted intrusions as described above.
WiPro „all in one“ Operating Instructions Page 3
1.7 Changing the handheld transmitter battery
- Unscrew the 3 screws on the back of the handheld transmitter
and open the casing.
- Remove the printed circuit board and remove the battery.
- Replace the battery with one of the same type (CR2032)
- When inserting the battery, make sure that the polarity is correct.
!!! Follow the labelling on the battery holder !!!
1.8 Changing the transmitter battery of the magnetic contact
- Open the casing by gently levering up by the notch
on the narrow side of the casing.
- Remove the printed circuit board and remove the battery.
- Replace the battery with one of the same type (CR2032)
- When inserting the battery, make sure that the polarity is correct.
!!! Follow the labelling on the battery holder !!!
1.9 Changing the transmitter battery of the cable loop
- Unscrew the 2 screws on the bottom of the cable loop and
open the casing.
- Remove the battery without pulling out the printed circuit board.
- Replace the battery with one of the same type (CR2032)
- When inserting the battery, make sure that the polarity is correct.
!!! Follow the labelling on the battery holder !!!
- Insert the black seal in the casing cover and screw the casing closed.
- Only tighten the screws lightly so as not to crush the seal too much.
1.9.1 Sequence of a burglary alarm
If an opening which is secured with a wireless magnetic contact is opened,
a cable loop is cut or removed from its holder or a cab door is opened when
the system is armed, it will display this as a burglary alarm.
The siren and the horn (depending on the vehicle type)
sound(s) for about 30 seconds.
The interior beeper beeps for about 30 seconds.
The vehicle indicators flash for about 180 seconds.
The status LED flashes for about 180 seconds.


GB