Thitronik WiPro, Installation Manual

Page: 128 / 292

WiPro „all in one“ Operating Instructions Page 2
1.4 “Open contact” signal (ventilation function)
When locking, the interior beeper emits a series of short beeps.
This means that the system has detected that one of the wireless magnetic
contacts is open.
If none of the contacts have been opened intentionally,
check all the secured openings.
Unlike a passenger vehicle alarm system, in a motor caravan or caravan,
you might well want to leave a window open while all the other secured
openings are monitored. For example, if you need to ventilate the vehicle.
Read the following to see how this can be done.
Open the window you want to and activate the system as previously
described under Point 1.1 or 1.2.
When locking, the interior beeper emits a series of short beeps.
However, the alarm is armed and monitors all the remaining
contacts and the drivers cab.
If the window is closed while the system is activated,
the alarm is not triggered. The alarm does not sound
until at least 5 seconds have elapsed
before a window is opened again.
1.5 “Transmitter battery low” signal
When locking, the interior beeper emits a long continuous beep.
This means that one of the batteries of a wireless transmitter
is low and must be replaced. This may be the battery of
a wireless magnetic contact, a wireless handheld transmitter
or a cable loop.
Each transmitter must be triggered to determine which one it is.
The red “transmit LED” of the one concerned will go out after
approx. 30 seconds. Changing the battery, see 1.6.
1.6 Changing the transmitter battery
The memories of the transmitters are not volatile, i.e. once assigned, transmitters
do not have to be re-assigned after the battery has been changed.
To prevent the electronics from being damaged from static discharge,
earth yourself by touching an earthed part of the vehicle (door hinges or negative
contact of the cigarette lighter).









GB