Controller operating manual
15.11.2020 – Version 1.1
TCS.2 series –
thermofin
®
control system 2
nd
generation
Page: 60/162
Operating manual - translation into English © thermofin GmbH
Picture 32
Change factory parameters
Access to this area is reserved for the manufacturer and is protected with the manufacturer
password.
At this level, the fan can not only be parametrized (as under
A
) but also re-addressed or the address
can be reset to the factory setting.
①
Function selection:
“Parametrization and addressing manually”
- All parameters set in chap 4.4 (Fans settings) are written to fan.
- The addresses entered manually (see
②
) are written to the fan.
“Parametrization and addressing automatically”
- All parameters set in chap 4.4 (Fans settings) are written to fan.
- The fans are being re-addressed. After each successful addressing process, the
“Fan number new” (see
②
) is automatically counted. Starting with 1 up to the edited
“Number of fans per unit” (see chapter 4.4.3 “
“Fan(s) - only parametrization”
- All parameters set in chap 4.4 (Fans settings) are written to fan.
- The address set is not changed.
“Reset fan address(es)”
- The addresses of all fans connected to the BUS and supplied with voltage are reset
to “Factory settings”.
①
Function selection
②
Entering fan number old / new
Text messages / notes
