Controller operating manual
15.11.2020 – Version 1.1
TCS.2 series –
thermofin
®
control system 2
nd
generation
Page: 16/162
Operating manual - translation into English © thermofin GmbH
Circuit 1
Devices that only have one hydraulic line with the corresponding sensor (temperature or pressure)
are referred to as “single-circuit”. The sensor is selected automatically when the factory settings are
loaded (chapter 4.1.3). This marked display “Circle 1” shows the
setpoint
(editable in the main menu
Setpoints
(chapter 5.6) and the
actual value
(measured by the sensor) for this string. Both values
influence the internal controller 1.
If the operating mode “Slave operation” is selected, the “Control value” (specified in percent) is
displayed instead of the setpoint. The actual value display remains.
To switch slave operation on or off, two settings must be made in the “Control” menu:
-
Device settings
Control
Slave
control value
“select the desired control signal
” (chapter 4.2.5)
-
Device settings
Control
Inputs
/
Outputs
Analogue
IN
basic unit
Analogue
IN
3
“
Slave speed 1
” (chapter 4.3.3)
Circuit 2
If a two-circuit or multi-circuit device is selected, the
setpoint
and
actual
value
for the second
hydraulic line are displayed under the display of the first circuit. The sensors are selected
automatically when loading the factory settings (chapter 4.1.3). This setpoint can also be edited in
the main menu
Setpoints (chapter 5.6). The setpoint and actual value from circuit 2 influence
internal controller 2.
If the operating mode “Slave operation” is selected, the “Control value” (specified in percent) is
displayed instead of the setpoint. The actual value display remains.
To switch slave operation on or off, two settings must be made in the “Control” menu:
-
Device settings
Control
Slave
control value
select the desired control signal
(chapter 4.2.5)
-
Device settings
Inputs
/
Outputs
Analogue
IN
basic unit
Analogue IN 4 “
Slave speed
2
” (chapter 4.3.3)
Logo / Manual
The thermofin
®
logo is displayed here in normal operation. However, if manual operation of a digital
or analogue output is activated, a yellow hand symbol appears with the information which output is
currently set to manual operation.
By pressing the yellow highlighted information window, the user gets directly to the
corresponding, still activated, output.
