Terumo CDI 550, Operator'S Manual

Page: 88 / 173

troubleshooting chapter 9 9-3
Message/Problem Meaning and Corrective Action
Arterial (or Venous)
module SRS failure.
Press “cancel” to return
to configuration screen,
or “retry” to repeat test.
This failure indicates a module has failed its refer-
ence sensor test. Make sure that the module to be
used is properly in place on the side panel and the
cable-head surface is clean and undamaged; then
repeat the test. If this message appears again after
verifying proper placement in the holder, you have
the option of excluding the use of this module. Press-
ing “cancel” returns you to the configuration screen
so you can choose a different configuration excluding
the failed module. Pressing “retry” repeats the test. If
the problem persists, contact your Terumo Technical
Service representative to arrange for repair.
Note:
The printer records the final result of this test.
H/S module color chip
failure.
Press “cancel” to return
to configuration screen,
or “retry” to repeat test.
The CDI H/S Module has failed its color chip test.
Make sure that the CDI H/S Module is properly in
place on the monitor side panel and the color chip
and module optical surfaces are clean and undam-
aged; then repeat the test. If this message appears
again after verifying proper placement in the holder,
you will have to return to the configuration menu and
exclude the CDI H/S Module from use. Pressing
“cancel” returns you to the configuration screen so
you can choose a different configuration. Pressing
“retry” repeats the test. If the problem persists, con-
tact your Terumo Technical Service representative to
arrange for repair.
Note: The printer records the final result of this test.