Terumo CDI 550, Operator'S Manual

Page: 16 / 173

introduction chapter 1 1-11
(25)
Power cord connector.
The receptacle for the power cord (when connected to
an AC power supply).
(26)
Power cord.
The CDI System 550 hospital grade AC power cord.
(27) Fuse holder. Contains two fuses.
(28) Cable guide. Excess cable can be wrapped here for convenient storage when
not in use or during transport of the monitor.
(29)
Handle.
Allows the monitor to be carried or steadied during placement.
(30)
Monitor bracket.
Allows easy mounting (and dismounting) of the monitor to
the monitor pole clamp tray.
(31) Printer cover. Protects the printer and paper from spills.
(32) Ground equalization stud. This stud is used to reduce differences of electrical
potential between bodies of medical electrical devices and conductive parts of
other objects.
Calibrator
The CDI Model 540 Calibrator is designed for automatic calibration of the CDI Sys-
tem 550 Monitor and CDI Shunt Sensors, utilizing tonometered gases. The device is
designed so that two sensors can be calibrated at the same time.
Note: If only one CDI Shunt Sensor is to be calibrated, either calibrator pocket can be
used. Gas flow will be automatically shut off to the unused cable-head pocket.
(1) Calibrator cable. Connects the calibrator to the monitor. Once connected, the
calibrator receives its power from the monitor.
(2)
Calibrator gas bottle receptacles.
These hold the Gas A and Gas B bottles
properly, to ensure correct calibration.
(3)
Calibrator pockets.
Supports and aligns the sensor/cable-head assembly
during calibration.
A
B
5400111
(2)
(3)
(1)
(4)
(5)