Terumo CDI 550, Operator'S Manual

Page: 12 / 173

introduction chapter 1 1-7
Note: The hemoglobin measurement technique used in this instrument measures
total hemoglobin, and therefore includes other hemoglobin species such as carboxy-,
met-, sulf-, and fetal hemoglobin. Terumo CDI blood parameter monitoring systems
are intended to monitor blood gas values including pH, PCO², PO², K+, Oxygen Satu-
ration (SO²), Hematocrit (HCT), and Hemoglobin (Hgb). When used in accordance
with their instructions for use, the systems have been demonstrated to provide reliable
reports of these values with an accuracy characterized in Appendix B of the Opera-
tor’s Manual.
Caution
• Failure to follow the instructions can cause the monitoring system to display
inaccurate values.
The accuracy of the results is dependent upon the following:
• Reading and understanding the instructions for use
• Proper set-up, full two point tonometered gas calibration, and complete
calibration of the potassium sensor and all other parameters
• Use of all available system features
• Periodic comparison to a laboratory reference sample
CDI System 550 components
Monitor
The next figure shows the front panel of the monitor (with
Ḋ
O
2
enabled).
Note: The screens in this manual reflect a particular configuration of modules
(“Arterial/Venous Blood Gases & Hematocrit/Saturation”). If you have a different set of
modules, your screens will look different from the ones in this manual.
331
D02
calibration
9-25-18
pH-stat
° C
(11) (10) (1) (2) (4) (8)
(5) (12)
(3) (7)
(9)
(13) (6)