Terasic Altera Cyclone V GX Starter Kit, User Manual

Page: 60 / 95

59

System Configuration
Under the System Configuration users are given the flexibility of enabling their choice of included
components on the board as shown in
Figure 4-4 . Each component of the board is listed where
users can enable or disable a component according to their design by simply marking a check or
removing the check in the field provided. If the component is enabled, the C5G System Builder will
automatically generate the associated pin assignments including the pin name, pin location, pin
direction, and I/O standard.
Figure 4-4 System Configuration Group

GPIO Expansion
Users can connect GPIO daughter cards onto the GPIO connector located on the development board.
As shown in
Figure 4-4 , select the daughter card you wish to add to your design under the
appropriate HSMC connector to which the daughter card is connected. The System Builder will
automatically generate the associated pin assignment including pin name, pin location, pin direction,
and I/O standard.
Note, the GPIO header share bus with 7-segments HEX3 and HEX2. So, when GPIO header is used,
the 7-segments only HEX0 and HEX1 are available as shown in "7-Segment x2" in
Figure 4-5 .
Also, in physically, users need to setup S1 and S2 dip switch to off position as shown in Figure 4-5 .
The S1 and S2 are located in the back of the Cyclone V GX starter board.