GS2101M IP2WiFi Adapter Command Reference Guide
1VV0301499
Rev. 2.0 176
2019-08-05
8.2 Live Calibration
8.2.1 Enable Live Calibration
This command is used to enable or disable live calibration.
When live calibration is enabled,
•
It is scheduled to start in the next boot based on the commands related to the
following:
–
Scan
–
Associated state
–
Unsolicited Tx and unsolicited Rx
–
RF commands
–
Standby
•
It enables RF calibration on a fully assembled unit.
•
Factory calibration data from OTP-one time programmable data is used until live
calibration data is available in flash.
•
The configured parameter value remains the same unless manually changed.
When live calibration is disabled,
•
It aborts any live calibration that is in progress.
•
Partial data is not written and not erased from flash.
•
Factory calibration data from OTP data is used for RF calibration.
•
The configured parameter value remains the same unless manually changed.
Command Syntax
AT+WLCALEN=<value>
NOTE:
This command is obsolete and it is retained for backward compatibility.
NOTE:
1.) Erase command deletes all the settings and enables live calibration by default.
When fresh live calibration data is required, issue Erase command before
enabling live calibration
2.) Once live calibration is enabled, a cold boot reset/reset need to be performed
for it to take effect. Standby option is not allowed.
3.) Live calibration is enabled by default.
