GS2101M IP2WiFi Adapter Command Reference Guide
1VV0301499
Rev. 2.0
24
2019-08-05
–
Interface enters the command processing state.
Figure 2 Operating Modes of the IP-to-WiFi Application
IP-to-WiFi binary uses the interface and configuration as per the binary configuration
options selected in SDK Builder. The evaluation binary packages use the following
defaults:
•
For UART: 115200 baud using 8 bit characters with no parity bits, one stop bit, and no
flow control
•
For SPI: SPI Mode 0 (CPL=0, CPH=0)
Any changes to this configuration that were made in a previous session using the ATB
command (see
3.2.1.1 UART Parameters, page 33
) will be lost when power is lost. To
make changes in the UART/SPI parameters that will persist across power cycling, the
relevant changes must be saved into the power-on profile using AT&W (see
) and AT&Y (see
4.3.4 Select Default Profile, page 67
2.3.1 Profile Definition
The configuration parameter values that define the behavior of the GS node are grouped
into Profiles. These profiles are stored in non-volatile memory when not in use. The GS
node supports two Profiles by default.
