Telit Wireless Solutions GS2101M Series, Command Reference Manual

Page: 163 / 196

GS2101M IP2WiFi Adapter Command Reference Guide
1VV0301499
Rev. 2.0 163 2019-08-05
Table 145, page 164 describes the Asynchronous Frame Transmission Data Rates
Note: for continuous transmission, configure this parameter with the value 99. Once configured in continuous
transmission mode, to come out of this mode, stop the test mode and start the test mode again (i.e.,
AT+WRFTESTSTOP, AT+WRFTESTSTART).
FrameLen
Mandatory 32 to 1500 The length of the payload.
TxRate Mandatory N/A
The rate at which the data need to be
sent. See
Table 145, page 164 .
Note: This also depends on the HtEnable field. If HtEnable bit is set, the configured TxRate is taken as MCS index,
otherwise legacy rate.
TxPower Mandatory 0 to 27
The value of this parameter can range
from 0 to 27. Where 27 is the index
corresponding to the maximum
TxPower GS node will support.
DestAddr Mandatory N/A
The MAC address of the node target to
reach.
BSSID Mandatory N/A
The MAC address of any arbitrary AP,
which will be the source MAC
address.
HtEnable Mandatory
0 High throughput disabled
1 High throughput enabled
GuardInterval Mandatory
1 Short guard interval
0 Long guard interval
GreenField Mandatory
0 11 n disabled
1 11 n only
PreambleType Mandatory
0 short
1 long
QosEnable Mandatory 0 Enable QoS
AckPolicy (Debug parameter) Mandatory 4 N/A
Scrambler (Debug parameter) Mandatory
0 OFF
1 ON
AifsnVal Mandatory N/A N/A
Antenna Mandatory N/A N/A
ccaBypass Mandatory N/A N/A
Table 144 Asynchronous Frame Transmission Parameters
Parameter Optional/Mandatory Value Description